Connecting The Cgy750 - FUTABA CGY750 Instruction Manual

C CGY750
ONNECTING THE
OLED Display
• Displays menus, parame-
ters and status information.
Edit Keys
• Used when setting data.
• Use the included plastic ad-
justment screwdriver to press
the buttons.
Connection to the receiver, servos and sensors
S.BUS channel setting
(1) Gyro Sensor:
• Connect the gyro sensor.
*Insert the sensor connector until it is
firmly locked.
(1)
(2) Rsen (Revolution sensor):
(2)
• Connect the revolution sensor.
(3)
(3) S.BUS:
• Connect to the S.BUS output of the
receiver with the supplied extension.
(4) AIL Output:
(4)
• Connect the aileron servo.
(5)
(5) ELE Output:
• Connect the elevator servo.
-
(6) (6) PIT Output:
• Connect the pitch servo.
(7) TH Output:
• Connect the throttle servo.
• Connect the ESC w/BEC and set the
operation mode to Gyro+THR mode.
(7)
(7) E2 2nd ELE Output:
• Connect the second elevator servo.
(Swash mode: H4-00 or H4-45)
(8) RUD Output:
(8)
• Connect the rudder servo.
-
Using the CGY750 with a electric helicopter
-
DANGER
It is necessary to remove the pinion gear from the electric motor
or disconnect the motor from the ESC before powering the model
up for setup or bench testing. Electric motors are extremely pow-
erful and capable of delivering the power instantly, causing injury
to yourself, others, or the surroundings.
-
5
Installing the Sensor Connector
WARNING
You will feel resistance at two points
when inserting the connector. Make sure
that you plug in the connector completely,
or connection problems may result.
1) First resistance (incomplete
connection)
Locking tab
2) Second resistance (fully
connected)
Your transmitter
s h o u l d b e r e s e t
t o t h e d e f a u l t
Swash Type
settings and the
swash plate type
H-1
selected with the
transmitter should
be set to Normal
( H -1) o r s i n g l e
servo mode. All
CCPM mixing is set up and handled
with the CGY750, and the transmitter
functions should not be used. Before
starting helicopter set-up, be sure
that all dual rates, pitch curve, and
endpoint values are set to 100/100.
-
-
-