S.bus Wiring Example; Power Supply - FUTABA T16SZ Instruction Manual

*When using 8/SB as S.BUS, you must set
the receiver to Mode B or Mode D. See
R7008SB CH MODE TABLE
Receiver
WARNING

Power supply

Please make sure that you use a battery that can deliver enough capacity for
the number and kind of servos used. Alkaline batteries cannot be used.
*When using 8/SB as S.BUS, you
must set the receiver to Mode B
or Mode D. See R7008SB CH
MODE TABLE.
●S.BUS Servo
Page 33
.
Since the channel number is memorized by the S.BUS itself, any
connector can be used. When the SBD-1, SBD-2 (sold separately)
is used, ordinary servos can be used with the S.BUS system.
*SBD-1 S.BUS Decoders cannot be used by S.BUS2 port.
●When separate power supply used
When a large number of servos are used or when high
current servos are used, the servos can be driven by a
separate power supply by using a separate Power
Supply 3-way hub with orange connector.
S.BUS Gyro CGY750
Connection example
Receiver
Optional Parts
●6-Terminal box
(TB16PP)
Six connectors can be
inserted
●Hub（Another power
supply）
Used when using a
separate power supply
battery.
Orange
●Hub
Three connectors can be
inserted.
Green
＜ Before Use ＞
37