Advertisement
Commissioning
After reading the installation instructions carefully, you can start the new pump if you note the following
aspects:
•
Check if the pressure pipes have been installed properly.
•
Make sure that the electrical connection is 230V~50Hz.
•
Check if the socket is in proper working order.
•
Make sure that moisture or water never reaches the mains connection.
•
Avoid that the pump operates dry.
•
Don't use the pump without filter basket, this protects the pump from large debris that can lead to
blockage of the pump.
Hints for maintenance!
The pond motor pump is a maintenance-free and a practice-proven quality product that was subjected
to rigorous final inspections. For a long working life and continuous operation we recommend regular
checking and proper care.
Maintenance and Cleaning
Overload protection:
The pump has an integrated overheat protection. After the pump is stopped it has to cool down for a
while due to the overheat control device, before it runs again. In case it does not run again by itself,
the following checks shall be conducted:
Could the pump cool down sufficiently due to the overheat protection after being stopped?
Is the water supply sufficient?
Is the filter clogged?
Is there dirt in the pump housing?
Is the hose or the pipe clogged?
Is the hose broken, too long?
Construction of the Pumpe:
1
Adjuster*
2
Filter Basket
3
Pump Housing
*depending on the modell. Adjustable are the models 50199-50216, the models 50217-50220 can not be con-
trolled.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
>
Improve the water supply!
>
If necessary rinse the filter!
>
Perform cleaning!
>
Clear the hose/pipe!
>
Check, replace, shorten!
4
Rotor subassembly
5
O-Ring
6
Bearing
Version 3. 2017
7
Motor Body
8
Seal
9
Outlet
10
Outlet Nut
11
1 ¼" Outlet
Seite 14
Advertisement
