Table of Contents
Advertisement
CONFIGURATION
5
CONFIGURATION
This section describes the programming method of using configuration barcode
symbols to program your reader. By using the Lynx™ BT reader to read/decode
these special configuration symbols, you can configure, and obtain information from
its system software.
When you are reading configuration barcode symbols, carefully aim the 2D reader to
avoid reading adjacent symbols.
The configuration barcode symbols in this chapter are divided into logical
sections according to the type of configuration required, (RS232 configuration,
Code selection, etc.). On top of each section it is indicated the device (Lynx™
Bt reader or OM-1000 BT cradle) to be configured through the selected
parameter group, see the example:
Section
Title
If arguments are required with a command, you can read additional barcode
labels (typically digits) from Appendix A.
During configuration be careful that the selected section
contains parameters configuring the device you are working
with.
NOTE
Device to be Configured
Figure 8 – Configuration Page Example
5
29
Advertisement
Table of Contents
