Hookups And Settings; Overview; Step 1: Unpacking - Sony HT-RD150 Operating Instructions Manual

Hookups and Settings

Overview

Complete the following steps to start using this
home theatre system.
Step 1: Unpacking (page 5)
m
Step 2: Connecting the Speakers (page 7)
m
Step 3: Connecting the FM/AM Aerials (page 10)
m
Step 4: Connecting the Other Components (page 11)
m
Step 5: Connecting the Mains Leads (page 14)
m
Step 6: Basic Speaker Setup (page 15)
Notes
• Plug cords securely to prevent unwanted noise.
• See the instructions supplied with the components to be
connected.
• Be sure to disconnect the mains lead of each
component before connecting.

Step 1: Unpacking

Check that you have the following items.
• Active subwoofer (1)
• Centre unit (1)
• Speakers (4)
• AM loop aerial (1)
• FM wire aerial (1)
• Speaker cords (short × 2, long × 2)
• Optical digital cord (1)
• Remote commander (remote) (1)
• R6 (size AA) batteries (2)
• Foot pads for subwoofer and speakers (front/
surround)*
• Operating Instructions (1)
• Hookup Guide (card) (1)
* Attach the pads to the bottom of the speakers to prevent
speaker vibration or movement while listening (large
for the subwoofer, small for other speakers).
Inserting batteries into the remote
You can control the system using the supplied
remote. Insert two R6 (size AA) batteries by
matching the 3 and # ends on the batteries to the
markings inside the compartment.
Point the remote at (remote sensor) on the
centre unit when operating the system.
5
,continued