Table of Contents
Advertisement
Disconnect the plug from the power source before making
adjustments, changing accessories, or storing power tools. Such
preventive safety measures reduce the risk of starting the power tool
accidentally.
Store power tools, when not in use, out of the reach of children and
do not allow people who are not familiar with the power tool or these
instructions to operate it. Power tools are potentially dangerous in the
hands of untrained users.
Maintenance. Check for misalignment or jammed moving parts,
breakages or any other feature that might affect the operation of the
power tool. If it is damaged, the power tool must be repaired. Many
accidents are caused by using poorly maintained power tools.
Keep cutting tools sharp and clean. Properly maintained cutting tools
with sharp cutting edges are less likely to jam and are easier to control.
Use the power tool, accessories and cutting tools, etc., in accordance
with these instructions and in the manner intended for the particular
type of power tool, taking into account the working conditions and
the work which needs to be done. Using a power tool in ways for which it
was not intended can lead to potentially hazardous situations.
5.5
Service
Your power tool should be serviced by a qualified specialist using
only standard spare parts. This will ensure that it meets the required
safety standards.
6 SPECIFIC SAFETY WARNINGS
Check that the maximum speed indicated on the grinding disc corresponds to
the maximum speed of the machine. The speed of the machine must not
exceed the value on the grinding disc.
Make sure that the dimensions of the grinding disc correspond to the
specifications of the machine.
Make sure that the grinding disc has been mounted and fastened property. Do
not use reducing rings or adapters to make the grinding disc fit property.
Treat and store grinding discs in conformance with the supplier's instructions.
Do not use the machine for grinding work pieces with a maximum thickness
exceeding the maximum grinding depth of the grinding disc.
Do not use grinding discs for deburring.
When grinding discs have to be mounted on the thread of the spindle, make
sure that the spindle has sufficient thread. Make sure that the spindle is
sufficiently protected and does not touch the grinding surface.
Before use, inspect the grinding disc for any damage. Do not use grinding
discs which are cracked ripped or otherwise damaged.
Before use let the machine run idle for 30 seconds immediately switch off the
machine in case of abnormal vibrations or occurrence of another defect.
Carefully inspect the machine and grinding disc before switching the machine
on again.
Make sure that sparks do not put people into danger or that they contact
highly flammable substances.
Make sure that the work piece is sufficiently supported or clamped. Keep your
hands away from the surface to be cut.
Copyright © 2015
FE1-20
P a g e
| 6
EN
www.Ford-tools.com
Advertisement
Table of Contents
