Table of Contents
Advertisement
9.2
Splitting (fig 6)
Great danger of injury! Splinters of splitting disc may be ejected
at a very high speed.
Do not apply any side pressure to the wheel, as the cutting
wheel can jam and burst.
1.
Fit the cutting disc.
2.
Switch the tool on and run it first without load.
3.
Hold the motor block at an angle between 30°and 45°to the work-piece.
4.
Guide the disc slowly and evenly along the planned line of cut.
10
CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull
the power plug.
10.1 Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the
engine.
Regularly clean the machine housing with a soft cloth, preferably after each
use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc.
These solvents may damage the plastic parts.
10.2 Lubrication
The machine requires no additional lubrication
11
FAULTS
Should a fault occur e.g. wear of a part, please contact your local Ford Power-
tools dealer.
12
TECHNICAL DATA
MODEL
Voltage / frequency
Power input
No-load speed
Disc diameter
Spindle dimension
Weight
Copyright © 2015
FE1-20
FE1-20
230-240V~ 50Hz
600W
-1
12000 min
115 mm
M14
2.5 kg
P a g e
| 9
EN
www.Ford-tools.com
Advertisement
Table of Contents
