Installing And Charging The Batteries - Intermec PB42 Quick Start Manual

What is the PB42 Printer?
The PB42 printer is a rugged receipt printer designed for use
with the CK60 computer. The PB42 provides:
• Print resolution of 203 dpi
• Print speeds up to 8.5 cm (3.3 inches) per second
• Serial or Bluetooth™ communication options

Installing and Charging the Batteries

The PB42 ships with two batteries. You need to fully charge the
batteries before you can use the printer. You can charge the
batteries inside the PB42 printer or in the CK60 battery charger.
To charge the batteries in the PB42 printer, you need an AC
power adapter (P/N 851-076-001) and a power cord.
Use Intermec battery pack P/N 318-015-001 only.
Use of another pack may present a risk of fire or
explosion.
Employez le bloc-batterie d'Intermec P/N 318-
015-001 seulement. L'utilisation de tout autre
bloc-batterie présente un risque d'incendie ou
d'explosion.
The battery pack used in this device may present a
fire or chemical burn hazard if mistreated. Do not
recharge, disassemble, heat above 100 C (212 F) or
incinerate.
Le bloc-batterie utilisé dans cet appareil peut
présenter un risque d'incendie ou de brûlure
chimique en cas de mauvais traitement. Ne
rechargez pas, ne désassemblez pas, ne chauffez pas
à une température supérieure à 100 C (212 F) et
n'incinérez pas ce bloc-batterie.
Dispose of used battery pack promptly. Keep away from
children.
It takes about 4 hours to charge the batteries inside the PB42.
PB42 Printer Quick Start Guide 1