Kit Contents Check List; Approvals; Limited Warranty - Re-Verber-Ray DX3-20-50 Insert Manual

5.0 Parts •

Kit Contents Check List

Kit Contents Check List
Chart 5.2 • Kit Contents for DX3 Series - Reference the length column for your model.
TP-19B 4" Hanger with
Reflector Tension Spring
**TP-19C
TP-83 24" Stainless Steel
Flexible Gas Connector
**TP-83A
Part No.
Description
TP-19B 4" Hanger w/ Tension Spring
TP-21B 4" Tube Clamp
TP-82 4" Reflector Center Support
TP-83 24" S.S. Flexible Gas Connector
TP-105 Reflector End Cap
TP-106 Reflector End Cap Clips
LIOGT3 General Tube Heater Manual
LIODX3 DX3 Series Insert Manual
Additional kit contents as supplied when heater is configured with Add-On Options (if applicable)
TP-25 1/4" Female Spade Terminal (24VAO)
Filled By:
* NOTE: One 4" stainless steel tube clamp (P/N: TP-220) is provided for each 150,000 - 200,000 BTU/h model.
Place as shown on page 11.
** Part number for models upgraded with stainless steel options.

Approvals

• CSA.
• Indoor approval.
• Outdoor approval with OD-Kit.
• Commercial approval.
Printed in U. S. A.
DX3 Series Kit Contents
TP-82 4" Reflector
Center Support (RCS)
**TP-829
TP-21B 4" Tube Clamp
**TP-220
20 ft.
3
2
2
1
2
8
1
1
2
© 2013 Detroit Radiant Products Co.
21400 Hoover Road • Warren, MI 48089
Phone: (586) 756-0950 Fax: (586) 756-2626
www.detroitradiant.com • sales@drp-co.com
TP-105 Reflector End Cap
**TP-105A
LIOGT3 Tube Heater
General Manual
Detroit Radiant Products Co.
Tube Heater
General Manual
To be used in conjunction with Series 3 insert manuals.
WARNING
!
Improper installation, adjustment, alteration, service or maintenance can cause
property damage, injury or death. Read and understand the installation, operating and
maintenance instructions thoroughly before installing or servicing this equipment.
This heater must be installed and serviced by trained gas installation and service
personnel only. Failure to comply could result in personal injury, asphyxiation, death,
fire and/or property damage.
In locations used for the storage of combustible materials, signs must be posted to
specify the maximum permissible stacking height to maintain the required clearances
from the heater to the combustibles. Signs must either be posted adjacent to the
heater thermostats or in the absence of such thermostats, in a conspicuous location.
For Your Safety
If you smell gas:
• Do not try to light any appliance. • Immediately call your gas supplier from a neighbor's phone.
• Do not touch any electrical switch. • Follow the gas supplier's instructions.
• Do not use any phone in your building. • If you cannot reach your gas supplier, call the fire department.
Keep these instructions for future reference.
Form: LIOGT3-10211
Print:5M-4/11-r1_10/28/11(CDS)
Replaces:LIOGT3-3M-8/10 (CDS)
30 ft. 40 ft. 50 ft.
4 5
3 4*
3 4
1 1
2 2
8 8
1 1
1 1
2 2

Limited Warranty

• 1 year - Burner box components.
• 5 years - Combustion and radiant tubes.
• 10 years - Stainless steel burner.
• See page 36 of the General Tube Heater Manual
for terms and conditions.
20
DX3 Series
TP-106 Reflector
End Cap Clips
LIODX3 DX3 Series
Insert Manual
DX3 Series
Insert Manual
For complete installation instructions, see the Tube Heater General Manual
that accompanies this insert manual.
The DX3 Series Infrared Tube Heater is a positive pressure, single-stage radiant heater system. This
insert manual is a supplement to the Tube Heater General Manual and provides specific information
related to the DX3 Series model. All persons involved with the installation, operation and maintenance of
the heater system must read and understand the information in this insert manual and the accompanying
Tube Heater General Manual.
WARNING
!
Improper installation, adjustment, alteration, service or maintenance can cause
property damage, injury or death. Read the installation, operation and maintenance
instructions thoroughly before installing or servicing this equipment.
This heater must be installed and serviced by trained gas installation and service
personnel only. Failure to comply could result in personal injury, asphyxiation, death,
fire or property damage.
In locations used for the storage of combustible materials, signs must be posted to
specify the maximum permissible stacking height to maintain the required clearances
from the heater to the combustibles. Signs must either be posted adjacent to the
heater thermostats or in the absence of such thermostats, in a conspicuous location.
Not for residential use! Do not use this heater in the home, sleeping quarters,
attached garages, etc. Installation of a commercial tube heater system in residential
indoor spaces may result in property damage, serious injury, asphyxiation or death.
For Your Safety
If you smell gas:
• Do not try to light any appliance. • Immediately call your gas supplier from a neighbor's phone.
• Do not touch any electrical switch. • Follow the gas supplier's instructions.
• Do not use any phone in your building. • If you cannot reach your gas supplier, call the fire department.
Keep these instructions for future reference.
LIODX3-Rev. 00312
1M-8/10_r5-1/4/12(CDS)
Replaces: LIODX3-2M-9/09(CDS)
60 ft. 70 ft.
6 7 8
5* 6* 7*
5 6 7
1
1 1
2 2 2
8 8 8
1 1 1
1 1 1
2 2 2
80 ft.
9
8*
8
1
2
8
1
1
2