Digital ID View IV-THB4200AT User Manual page 13

Device Installation
Figure 3-3 Pushing the camera to the bottom base
Step 5
Wire the camera and hide the visible cables. After the wiring, rotate the camera to
make the camera align with the bottom base, as shown in Figure 3-4:
Figure 3-4 Aligning with the bottom base
Step 6
Secure the camera to the bottom base, as shown in Figure 3-5:
Figure 3-5 Securing the camera to the bottom base
Step 7
Align the focus fixture with the lens slot to make sure they are clipped together. Hold
the handle and make adjustment towards the direction indicated by the arrow, as shown
in Figure 3-6:
Figure 3-6 Focusing
Step 8
Adjust the shooting angle, as shown in Figure 3-7, and then tighten the screws.
Figure 3-7 Adjusting the shooting angle
----End
12
Thermal Imaging IP Camera
User Manual
Issue V1.0 (2015-11-25)