JVC KV-M705 Service Manual page 9

3.1.9 Removing the system control board
(See Fig.17)
• Prior to performing the following procedures, remove the front
assembly, top drive unit and rear bracket.
(1) From the top side of the bottom case assembly, remove the
five screws M attaching the system control board to the bot-
tom case assembly.
(2) Disconnect the wire from the connector
tem control board.
(3) Take out the system control board from the bottom case
assembly.
3.1.10 Removing the front key board
(See Fig.18)
• Prior to performing the following procedure, remove the front
assembly.
(1) From the back side of the front assembly, remove the spac-
er from the front key board.
(2) Remove the eight screws N attaching the front key board
to the front assembly.
(3) Take out the front key board from the front assembly.
Reference:
After reattaching the front key board, cover it with the new
spacer.
CN351 on the sys-
M M
CN351 System control board
Fig.17
N
Front key board Spacer
Fig.18
M
(No.MA209)1-9