3.1
Main body section
3.1.1 Removing the front assembly
(See Figs.1 to 3)
(1) From the both sides of the main body, remove the two
screws A attaching the front assembly to the main body.
(See Fig.1.)
(2) From the bottom side of the main body, release the two
claws a attaching the front assembly to the main body.
(See Fig.2.)
(3) Take out the front assembly forward from the main body.
(4) Lift up the lock lever of the connector
key board and disconnect the card wire from it. (See Fig.3.)
1-4 (No.MA209)
SECTION 3
DISASSEMBLY
CN471
on the front
A
Front assembly
Fig.1
Claws a
Fig.2
Card wire
Front key board
CN471
Fig.3
A
Front assembly
Front assembly