JVC KV-M705 Service Manual page 6

3.1.3 Removing the LCD assembly
(See Figs.7 to 10)
• Prior to performing the following procedures, remove the front
assembly and top drive unit.
(1) From the top side of the top drive unit, remove the three
screws D attaching the LCD assembly to the top drive unit.
(See Fig.7.)
(2) From the bottom side of the top drive unit, remove the two
screws E attaching the FPC guide and take out it. (See
Fig.8.)
(3) Move the LCD assembly in the direction of the arrow by
turning the feed gear. (See Fig.8.)
(4) From the top side of the top drive unit, remove the screw D
attaching the LCD assembly to the top drive unit. (See
Fig.9.)
(5) Take out the LCD assembly from the top drive unit.
Reference:
• When reattaching the LCD assembly, pass the flexible wire
through the slot c of the mecha assembly as before. (See
Fig.10.)
• When reattaching the FPC guide, pass it through the section
b as before. (See Fig.8.)
Bottom case assembly
LCD assembly Section b
Feed gear
1-6 (No.MA209)
D
Fig.7
Section b
FPC guide
E
Fig.8
LCD assembly
D
Bottom case assembly
Fig.9
Slot c
LCD assembly
Fig.10