Table of Contents
Advertisement
DECK MECHANISM DISASSEMBLY
PLATE CLAMP
CLAMP ASSEMBLY DISC
MAGNET CLAMP
CLAMP UPPER
Fig. 5-1
1. Holder Clamp (Fig. 5-1)
1) Release 1 Screws(S1).
2) Unhook 2 Locking Tabs(L1).
3) Lift up the Holder Clamp and then separate it from the
Base Main.
1-1. Clamp Assembly Disc
1) Place the Clamp Assembly Disc as Fig. (A)
2) Lift up the Clamp Assembly Disc in direction of
arrow(A).
3) Separate the Clamp Assembly Disc from the Holder
Clamp.
1-1-1. Plate Clamp
1) Turn the Plate Clamp to counterclockwise direction and
then lift up the Plate Clamp.
1-1-2. Magnet Clamp
1-1-3. Clamp Upper
HOLDER CLAMP
(A)
(S1)
(Fig. A)
HOLDER CLAMP
(L1)
BASE MAIN
HOLDER CLAMP
(L1)
TRAY DISC
EMERGENCY EJECT HOLE
(B)
BOTTOM SIDE VIEW
F
2. Tray Disc (Fig. 5-2)
1) Insert and push a Driver in the emergency eject
hole(A) at the right side, or put the Driver on the
Lever(B) of the Gear Emergency and pull the Lever(B)
in direction of arrow so that the Tray Disc is ejected
about 15~20mm.
2) Pull the Tray Disc until it is separated from the Base
Main completely.
5-2
BASE MAIN
(A)
LEVER
BASE MAIN
ig. 5-2
Advertisement
Chapters
Table of Contents
