Connection; Before The Connection; Connection Patterns - Rextron MACNM-H90 User Manual

------------------------Connection

Before the Connection

1. Install the software to the computer first BEFORE the physical
installation
2. Prior to the installation, ensure to power off all devices that will be
connected to this system.
3. Ensure that all devices you will connect are properly grounded.
4. Place cables away from fluorescent lights, air conditioners, and
machines that are likely to generate electrical noise.
5. Avoid locating the magnetic foot pad near any strong sources of
electromagnetic radiation such as CRT monitors, high power
electric cabling, audio equipments, especially tape recorders,
which are very sensitive to electron-magnetic fields.

Connection Patterns

For the maximum capability and extension, up to 4 Units can be
daisy chained and connected to an Ethernet Hub at a time.
Connect the provided power cord into an appropriate power source and
plug the opposite end into the power connector on the xtraCoN Unit.
The POWER LED on the top panel of the Unit flashes GREEN-BLUE
followed by steady BLUE indicating the power ON.
Use a HDMI/DVI/VGA cable for the connection between xtraCoN Unit
and the monitor display.
On the xtraCoN Unit, connect the mouse/keyboard to USB connectors
and Audio Jack to Speakers and MIC.
For LAN connection pattern , use CAT5 cables for the connection
among the xtraCoN series, source computer, and Ethernet Hub.
The LAN LED on the top panel of the Unit flashes BLUE to confirm
the connection.
For USB connection pattern , use a USB A-B cable for the connection
between the source computer and the xtraCoN models. The USB LED
on the top panel illuminates BLUE to confirm the connection.
11