Viewing Mode Display - Samsung SEW-3034WN User Manual

Viewing Mode Display

Wirelessreceiver
SEW-3034
Signalindicator
The signal indicator shows the strength of the signal being received from the
camera. The number of bars in the signal indicator shows the strength of the
signal – One or no bars indicate the signal is poor, and 4 bars indicate a strong
signal.
Cameranumber
Indicates the number of camera that is displayed on the current screen. Press
the [M] key on the receiver to switch between available cameras.
To automatically switch between channels, press the [A] key (AUTO).
`
n
For paring to add a camera, refer to "Pairing". (Page 12)
`
TriggerAlert
Indicates the type of alert when audio is detected on the camera.
The Trigger Alert volume will be adjusted with the applicable message on the
screen.
Press the [–] key to decrease the volume, and press the [+] key to increase the
volume.
Talk
It displays if you press and hold [
Indicates that it is on talking mode.
nightlight
If you press [ ] in the wireless receiver or wireless camera, the night light of
the wireless camera turns on with the applicable message.
10 · Installation
] in the left corner.
AutoMute
If you set Auto Mute to <YeS>, the applicable message appears on the screen.
MicroSdcardstatus
Indicates when a Micro SD card is inserted.
It displays the recording type if you press record button.
A/Mrecord
Press to auto record or manual record during monitoring.
REC A : Auto Recording - Start recording when the alarm is detected.
REC M : Manual Recording - Press to the button will be recorded.
Volumeadjustment
The receiver volume can be adjusted by using the [+], [–] keys when viewing a
camera.
Press the [–] key to decrease the volume, and press the [+] key to increase the
volume. When the volume is set to one bar (lowest setting), the volume will be
muted and no sound will be emitted by the device.
The volume adjustment icon will be displayed
during volume changes, and will disappear after 10 seconds of inactivity.
Alarm
Indicates if the alarm set to <on>.
Time/ZooM
Displays the time that is set in the current receiver.
Displays zoom size if it sets x2.
noSignalWarnings
You will see the following warning message when the camera is out of range of the
receiver.
The "ouToFrAnGe" message means the receiver cannot access the camera.
Please reposition the camera, or check the camera power.