PRESONUS StudioLive 16.0.2 USB Owner's Manual page 60

6 Digital Effects | Master Control
6.5 Using MIDI Control Mode to Remote-Control StudioLive
Setting Up Different MIDI Channels on Your FCB1010
not Program Change messages, so there is no chance of a conflict—unless
you assign the same CC message to two different StudioLive parameters.
In addition to setting your MIDI Channels and Control Change messages, you will
also need to set MIDI Control Mode to On and make sure the MIDI Source is set to the
StudioLive's MIDI Input. See the StudioLive 16.0.2 USB Software Reference Manual
for information on controlling your StudioLive via USB using Studio One Artist.
Navigate to Pages 3 and 4 of your StudioLive system menu
and set each page up as shown in these images:
Next, you need to configure the pedals on your FCB 1010 to send information
on different MIDI channels. We will use Pedal 1 exclusively for Scene changes,
Pedals 2 and 3 for FXA recall, and Pedals 4 and 5 for FXB recall. You can customize
your pedal to meet your needs; these instructions merely provide a guideline.
1. Boot your FCB1010 into Global configuration mode by holding
the Down pedal while powering on the FCB1010.
PreSonus recommends that you do not use Direct Select mode. When your
FCB1010 boots up, you will see that the green LED above Direct Select is
illuminated. Make sure that the red LED on pedal 10 is not illuminated.
2. Press the Up pedal to select MIDI Function.
3. Press Pedal 1 so that its red LED is flashing.
4. Press the Up Pedal again to select the MIDI channel for Pedal 1.
5. For our purposes, Scene recall is assigned to MIDI Channel
1. Press Pedal 1 so that the LED readout displays "1. "
6. Press the Up Pedal twice to confirm the change and cycle back to MIDI Function.
7. Next, you'll assign the MIDI channel for FXA Recall.
Press Pedal 2 so that its red LED is flashing.
8. Press the Up Pedal again to select the MIDI channel for Pedal 2.
9. This time, you will select MIDI Channel 2. Press Pedal
2 so that the LED readout displays "2. "
10. Press the Up pedal twice to confirm the change and cycle back to MIDI Function.
11. Repeat steps 8-10 for Pedal 3.
12. Repeat steps 8-11 for Pedals 4 and 5, selecting MIDI Channel 3 for each.
StudioLive™ 16.0.2 USB
Owner's Manual
56