Adjusting the Front Wheel Alignment
In the unlikely event that your trolley is not tracking in a straight line, the alignment of the front wheel can be adjusted to rectify
the fault. This problem can be caused by a number of factors including a slightly loose bag support or an unevenly packed golf
bag. Should you wish to alter the alignment of the front wheel, please follow these simple steps:
1.
Use a flat blade screwdriver to remove the plastic cap on the right hand side of the front wheel housing (fig. 1)
2.
Insert an Allen key into the fitting underneath and turn anti-clockwise to loosen slightly (fig. 2)
3.
There two small metal dials on either side of the housing that are used to realign the wheel (fig. 3 & 4)
4.
If your trolley is veering to the right, turn the left dial clockwise and the right dial anti-clockwise
5.
If your trolley is veering to the left, turn the right dial clockwise and the left dial anti-clockwise
6.
Tighten the Allen key bolt and cover with the plastic cap. You may need to apply a small amount of glue to secure fully
This procedure can be carried out until the trolley is moving in a straight line (you may only need to adjust one dial at a time).
Fig 1
Fig 2
Adjusting the Front Wheel Alignment
Fig 3
Fig 4
Page 3