Preferences - GE Digital Energy Multilin 239 Instruction Manual

MESSAGE L
MESSAGE M
MESSAGE L
MESSAGE M
4.2.1

Preferences

4–14
Courtesy of NationalSwitchgear.com
SEE PREVIOUS PAGE
MESSAGE 4
] PROGRAMMABLE
] MESSAGE
MESSAGE 3
MESSAGE 4
] PRODUCT OPTIONS
]
MESSAGE 3
] END OF PAGE S1
]
FIGURE 4–2: Setpoints Page 1 – 239 Setup
• TEMPERATURE DISPLAY: Select whether temperatures should be displayed in degrees
Celsius or Fahrenheit. Temperature units can be changed at any time.
• DEFAULT MESSAGE TIME: Up to 5 default messages can be selected to automatically
scan sequentially when the 239 is left unattended. If no keys are pressed for the
default message time set with this setpoint, then the currently displayed message will
automatically be overwritten by the first default message. After 5 seconds, the next
default message in the sequence will display if more than one is selected. Alarm and
trip messages will over-ride default message display. Any setpoint or measured value
can be selected as a default message. Refer to Section 3.1.6: Default Messages on
page –8 for information on removing and adding new default messages.
Default messages can be disabled by setting this setpoint to
is turned off, the currently displayed message will remain displayed until a condition
such as a trip alarm, or key press forces the 239 to display a different message.
CHAPTER 4: PROGRAMMING
Range: 40 Alphanumeric characters
Phone: (905) 294-6222
GEindustrial.com/pm
Range: NONE, RTD, AN, RTD-AN
SELECT OPTIONS TO
ENABLE: NONE
SELECT MOD 1 TO Range: 0 to 999
ENABLE: 0
SELECT MOD 2 TO Range: 0 to 999
ENABLE: 0
SELECT MOD 3 TO
ENABLE: 0
SELECT MOD 4 TO
ENABLE: 0
SELECT MOD 5 TO
ENABLE: 0
ENTER PASSCODE:
239 MOTOR PROTECTION RELAY – INSTRUCTION MANUAL
Range: 0 to 999
Range: 0 to 999
Range: 0 to 999
Passcode obtained from factory.
. When this setpoint
OFF