Canon TS9000 series Online Manual page 420

Note
• See Unplugging the Printer
• Cannot connect to the server. Please wait a while and try again.
The printer cannot connect to the server due to a communication error.
Tap OK on the touch screen and try again after a while.
Error Regarding Automatic Duplex Printing Is Displayed
See Automatic Duplex Printing Problems and take the appropriate action.
Check
Error Regarding Power Cord Being Unplugged Is Displayed
(Windows)
The printer may have been unplugged while it was on.
Check the error message that appears on the computer and click OK.
The printer starts printing.
See Unplugging the Printer
Writing Error/Output Error/Communication Error (Windows)
If POWER lamp is off, make sure printer is plugged in and turn it on.
Check1
The POWER lamp flashes while the printer is initializing. Wait until the POWER lamp stops flashing and
remains lit.
Make sure printer is properly connected to computer.
Check2
If you are using a USB cable, make sure it is securely connected to both the printer and the computer. When
the USB cable is securely plugged in, check the following:
• If you are using a relay device such as a USB hub, disconnect it, connect the printer directly to the
computer, and retry the printing. If printing starts normally, there is a problem with the relay device.
Contact the vendor of the relay device.
• There could also be a problem with the USB cable. Replace the USB cable and retry the printing.
to unplug the printer correctly.
for unplugging the power cord.
420