Table of Contents
Advertisement
3.3
Traverse mechanism assembly
3.3.1 Removing the pickup (See Figure 12, Figure 13)
• Prior to the following procedure, remove the traverse mecha-
nism assembly.
(1) Remove one screw D attaching the plate.
(2) Remove the plate and the leaf spring.
(3) Lift i of the shaft 1, and pull out the shaft 1 from j.
(4) Remove k of the pickup from the shaft 2.
Attaching the pickup:
(1) Engage k of the pickup to the shaft 2.
(2) A spring is lifted and shaft 1 is inserted in the j, and at-
tach the shaft 1 to i.
(3) Attach the leaf spring, and then attach the plate. Fix the
leaf spring and the plate by using the screw D.
spring
Leaf spring
Fig.12
Shaft 2
Part j
spring
Shaft 1
Fig.13
D
Plate
Part k
Part i
(No.YD095)1-15
Advertisement
Table of Contents
