Table of Contents
Advertisement
3.1.4 Removing the rear panel (See Figure 6 )
• Prior to performing the following procedure, remove the top
cover.
(1) Remove the four screws D attaching the rear panel.
(2) Disconnect the power cord from connector
main board
3.1.5 Removing the digital board and main board. (See Figure 7 ,Figure 8)
• Prior to performing the following procedure, remove the top
cover/front panel assembly/rear panel.
(1) Remove the two screws E attaching the digital board.
(2) Disconnect the card wire from connector CN201, CN202,
CN101, CN301, CN302,
(3) Disconnect the card wire from connector
main board.
(4) Remove the four screws F attaching the main board.
3.1.6 Remove the FL Display board (See Figure 9)
• Prior to performing the following procedure, remove the top
cover.
(1) Disconnect the card wire from connector
Display board.
(2) Remove the two screws G attaching the FL Dispiay board.
P901
on the
CN303
on the digital board.
CN903
on the
CN501
on the FL
Main board
P901
D
Fig.6
CN202
CN201
CN301
E
CN303
CN101
CN302
E
Digital board
Fig.7
CN903
F
F
F
F
Main board
Fig.8
Fig.9
D
Rear panel
CN501
G
G
FL Display board
(No.YD095)1-11
Advertisement
Table of Contents
