JVC XM-R700SL Service Manual page 9

< Removal of the MD mechanism >
Removing the Magnetic head board
1. Disconnect the magnetic head flexible harness
from the connector of the magnetic head board on
the holder assembly.
2. Remove the screw A attaching the magnetic head
board and pull out the magnetic head board from
the slit (a) in the direction of the arrow.
Removing the Magnetic head assembly
1. Disconnect the magnetic head flexible harness
from the connector of the magnetic head board on
the holder assembly.
2. Push the convex part b on the right side of the
head protector in the direction of the arrow. Lift the
right edge of the head protector (See Fig.4).
3. Pull the left tab of the head protector from the slit
(See Fig.5).
4. Remove the two B screws attaching the magnetic
head assembly on the underside of the chassis
assembly.
5. Pull out the magnetic head assembly in the
direction of the arrow while paying attention to the
magnetic head.
(See Fig.1 and 2)
(See Fig.2 to 5)
Chassis assembly
A
Slit a
Holder assembly
Magnetic head
board
Fig. 2
Magnetic head
Part c
C
d
Holder assembly
B
Pickup assembly
Fig. 3
XM-R700SL
Magnetic head board
Magnetic head
flexible harness
Fig. 1
Magnetic head
flexible harness
Magnetic head board
Magnetic head
flexible harness
Magnetic head
assembly
Pull
Head protector
Magnetic
head assembly
Underside of the
chassis assembly
1-9