JVC XM-R700SL Service Manual page 14

XM-R700SL
Removing the Feed motor
Prior to performing the following procedure,
remove the magnetic head assembly and the
pickup unit.
1. Peel the double-sided tape attaching the flexible
harness on the feed motor on the underside of the
chassis assembly.
2. Unsolder the part i
connected to the feed motor.
3. Remove the two I screws attaching the feed motor
base, then the feed motor base and the feed motor.
* When connecting the flexible harness to the feed
motor, use the double-sided tape to stick them fast.
1-14
(See Fig.15 and 16)
of the flexible harness
(See Fig.17)
Peel off
Double-sided tape
Fig. 15
I
Feed motor base
Fig. 16
Double-sided tape
Fig. 17
Flexible harness
Feed motor
Feed motor
Part i
Flexible harness
Feed motor