Control Panel Features - Westinghouse WH2200iXLT User Manual

FEATURES

CONTROL PANEL FEATURES

1 - 120-Volt, 20-Amp Duplex Outlet (NEMA
5-20R): The outlet is capable of carrying a
maximum of 20 amps.
2 - Reset Breaker: If the inverter is overloaded,
the reset breaker will trip. The engine will
continue to run, but there will be no output
from the inverter. Unplug the devices and
reduce the load. Push in the reset breaker to
reset it.
3 - Efficiency Mode Switch: When turned to the
ON position, the engine will sense the load
needed and run at a slower RPM to save fuel.
4 - Choke Knob: Pull out to the ON position
to start the engine, and push in to the OFF
position once the engine is running.
10
1
8
Figure 10 – Control Panel Features
3
2
7
6 5
5 - Output Ready LED: The light will be green
when the inverter is ready to be used.
6 - Overload LED: The red light will come on if
the inverter is overloaded. Decrease the load
before restoring inverter operations.
7 - Low Oil LED: The red light will come on
and the engine will shut down if the oil level
becomes low. You must add oil to the correct
level before the inverter can be restarted.
8 - Ground Terminal: The ground terminal is
used to externally ground the inverter.
4