Yanmar 2TNV70 Service Manual page 80

Industrial engines
Hide thumbs Also See for 2TNV70:
Table of Contents

Advertisement

PERIODIC MAINTENANCE
Clean Fuel Filter / Water Separator
DANGER
FIRE AND EXPLOSION HAZARD!
• Diesel fuel is flammable and
explosive under certain
conditions.
• NEVER use diesel fuel as a cleaning agent.
• When you remove any fuel system component
to perform maintenance (such as changing
the fuel filter) place an approved container
under the opening to catch the fuel.
• NEVER use a shop rag to catch the fuel.
Vapors from the rag are flammable and
explosive.
• Wipe up any spills immediately.
• Wear eye protection. The fuel system is under
pressure and fuel could spray out when you
remove any fuel system component.
• Failure to comply will result in death or
serious injury.
NOTICE
• ALWAYS be environmentally
responsible.
• Follow the guidelines of the EPA or other
governmental agencies for the proper disposal of
hazardous materials such as engine oil, diesel
fuel and engine coolant. Consult the local
authorities or reclamation facility.
• NEVER dispose of hazardous materials
irresponsibly by dumping them into a sewer, on
the ground, or into ground water or waterways.
• Failure to follow these procedures may seriously
harm the environment.
5-20
Periodic Maintenance Procedures
Periodically clean the fuel filter / water separator
element and inside the cup.
1. Position an approved container under the cup
(Figure 5-15, (1)) of the fuel filter / water
separator to collect the contaminants.
(2)
c
o
(10)
(4)
(3)
Figure 5-15
2. Close (Figure 5-15, (2)) the fuel cock
(Figure 5-15, (3)).
3. Turn the retaining ring (Figure 5-15, (4)) to the
left (Figure 5-15, (10)).
4. Carefully remove the cup (Figure 5-15, (1)) and
pour the fuel into an approved container and
dispose of properly. Hold the bottom of the cup
with a shop towel to prevent the fuel from
dripping. Wipe up any spills immediately.
5. Keep the retaining spring (Figure 5-15, (6)) and
float (Figure 5-15, (7)) handy for reassembly.
6. Remove the element (Figure 5-15, (8)) by
pulling it down.
7. Replace the element with a new one.
Applicable Mesh Filter Part No.
2TNV70
3TNV70
3TNV76
8. Wash the inside of the cup with clean diesel
fuel.
9. Check the condition of the cup O-ring. Replace
if necessary.
TNV IDI Service Manual
(9)
(5)
(6)
(1)
(7)
0000590B
171081-55910
(8)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

3tnv703tnv76

Table of Contents