Epson Stylus Photo R3000
Be sure to start the measurement from the top side of the chart.
Be sure to measure colors at each row two times.
During color measurement, do not allow the calibrator to rub against unmeasured
patches on the chart.
Prevent the ruler and calibrator from coming off the chart sheet during color
measurement. Doing so will cause incorrect color measurement.
During color measurement, measure only the patches on the chart sheet. Do not measure
other parts such as the USB ID text string.
When there is an error possibility in measuring color, a warning mark (
the patch in question. In such case, make sure to measure the row that includes the patch
with a warning mark again. If the same warning mark appears again at the same point,
ignore the marking and perform the measurement in the next line.
If the number of scanned patches does not match the number of patches on a single row,
the cursor stops at that row, the error mark (
row, and the following error message is displayed:
• "Color measuring by Eye-One calibrator has failed. Measure colors of the failed row
11. Click [Next], and write the Color ID to the printer. After the writing has finished, the Colorimetric
Calibration Tool automatically checks the Color ID.
12. When the following screen is displayed, click [End], and turn the printer OFF then back ON again to
complete the adjustment. This action reflects the color measurement values on the printer.
Adjustment
again."
Figure 2-35. Writing of Color ID
Details of Adjustments (TBD)
) appears on all of the patches on that
Figure 2-36. END
Revision A
) appears at
63
Confidential