Toro TITAN HD Series Setup Instructions page 5

9
Checking the Machine for
Grease
Parts needed for this procedure:
No. 2 lithium or molybdenum-based grease (purchase
1 tube
separately)
Procedure
Before you use the machine, check the machine for grease;
refer to Lubrication in the Operator's Manual.
10
Installing the Right Bumper
Parts needed for this procedure:
3 Locknut (3/8 inch)
3 Carriage bolt (3/8 x 2-1/4 inches)
Procedure
Mount the side bumpers in the top holes when operating in
height of cut higher than 64 mm (2-1/2 inches) and in the
center holes when operating in height of cut lower than 64
mm (2-1/2 inches).
1. Raise the mower deck to the 12.7 cm (5 inch) height
position (also the transport position).
2. The right bumper is zip tied to the machine for
shipping. Remove and discard the plastic zip ties.
1. Carriage bolt
2. Bumper (center-hole mounting shown)
3. Locknut
3. Move each bumper to the desired position and secure
it with 3 carriage bolts (3/8 x 2-1/4 inches) and 3
locknuts (3/8 inch).
4. Torque the bolts to 14 to 16 N∙m (10 to 12 ft-lb).
5
Figure 5