Toro TITAN HD Series Setup Instructions page 4

Figure 3
1. Roll bar in the upright position
2. ROPS knob in the latched position
3. Pull the ROPS knob out.
4. Rotate the ROPS knob 90 degrees.
5. ROPS knob in the unlatched position
3. Raise the roll bar to the full upright position while
pushing on the upper roll bar so that the pins snap into
position when the holes align with the pins.
4. Push on the roll bar and ensure that both pins are
engaged (Figure 3).
8
Checking the Grass Deflector
No Parts Required
Procedure
If there are plastic ties holding the grass deflector up, remove
them and lower the deflector into place.
WARNING
An uncovered discharge opening could allow the
machine to throw objects in the operator's or
bystander's direction and result in serious injury or
death. Also, contact with the blade could occur.
Never operate the machine without a cover plate, a
mulch plate, grass deflector, or bagger installed.
1. Make sure that one end of the spring is installed behind
the deck edge before installing the bolt as shown in
Figure 4.
2. Place the other end of the spring around grass deflector
(Figure 4).
Important: The grass deflector must be free to
rotate with downward tension. Lift the deflector up
to the full open position and ensure that it rotates
freely, without binding into the full down position.
1
G021 181
1. Grass deflector
2. Spring
4
2
3
4
4
3
Figure 4
3. End of spring
4. Deck edge
3
2