Instrument And Control Functions; Handlebar Switches; On/ " Switch; Switches - Yamaha XP530E-A Owner's Manual

Instrument and control functions

Handlebar switches

Left
1
1
2
3
2
4
5
3
6
7
4
1. Select switch "
2. Menu switch "MENU"
3. Dimmer/Pass switch "
5
4. Cruise control setting switch "RES+/SET–"
(XP530D-A)
5. Turn signal switch "
6
6. Horn switch "
7. Cruise control power switch "
(XP530D-A)
7
Right
8
9
10
1. Engine stop switch "
11
2. Mode switch "MODE" (XP530-A, XP530D-A)
3. Hazard switch "
4. "ON/ " switch
12
Dimmer/Pass switch "
Set this switch to "
13
beam and to "
To flash the high beam, push the pass
side "PASS" of the switch while the
14
headlights are on low beam.
EAU77490
/ "
/ /PASS"
/ "
"
"
1
2
3
4
/ "
"
EAU73921
/ /PASS"
" for the high
" for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.

"ON/ " switch

With the smart key turned on and within
range, press this switch to turn on the
power to the vehicle. Then with the sid-
estand up and while applying the front
or rear brake, push this switch to crank
the engine with the starter. See page
7-2 for starting instructions prior to
starting the engine.
Hazard switch " "
With the vehicle power is on or in park-
ing mode, use this switch to turn on the
hazard lights (simultaneous flashing of
all turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
5-1
EAU66040
/ "
". When re-
EAU66030
"
EAU77450
/ "
" before starting
" to
EAU77290
EAU79601