Worx WG169E Safety And Operating Manual page 13

plate until they lock into position so both the wheels are
facing in the forward direction (See Fig. B3). The wheels
should provide support when you are trimming in the
forward or reverse direction.
POSITION 2: USING THE GUIDE WHEELS WHEN
TRIMMING SIDE TO SIDE
Position the Grass Trimmer in the trimming position.
Underneath the Safety Guard there is a metal plate that
the Edger/Trimming Support Wheels will attach to. Slide
the Support Wheels vertically onto the metal plate until
it locks into position (See Fig. B2). The wheels should
provide support when you are trimming in a horizontal
side to side direction (See Fig. J2).
NOTE: you could also use the machine without the
guide wheels on guard when trimming.
POSITION 3: USING THE GUIDE WHEELS WHEN
EDGING (See Fig. I2)
WARNING: Make Sure the Safety Switch is
Locked Off to Prevent Accidental Starting.
Change the tool from trimming into the edging mode,
the Edger /Trimming Support Wheels (12) will attach on
the side the trimmer head as shown in Fig. B1, rotate
the main handle as described in ''MAIN HANDLE
ROTATION'', then unlock the Pivot Head Locking Knob,
and using adequate force, pull the trimmer head into
the desired position. Make sure to adjust the trimmer
head angle to be in the lowest horizontal setting.
Finally, lock the Pivot Head Locking Knob (See Fig. H3)
and position the wheel on the ground for the edging
mode. While edging, keep the Flower Guard/Edger
Guide aligned with the sidewalk edge, this will assist
to edge in a straight path. Only the tip of the line will
make contact with area being worked on. Do not force
the line. The edging wheels help protect the unit and
keep the unit from contacting the ground. Take extra
caution while edging, as objects can be thrown from
the trimmer line.
AUTOMATIC LINE FEED SYSTEM
When initially switching on the trimmer, a small length
of line is fed out. Each time the tool is started from rest
it will advance about 6.35mm of trimmer line.
A 'clattering' noise will be heard when the lines hit
the Line Cutter. DO NOT BE ALARMED this is quite
normal. After about 5 seconds the line will be cut to the
correct length and the noise will reduce as the motor
3 in 1: Trimmer / Edger / Mini mower
WG169E WG169E.2 WG169E.5 WG169E.9
H3
I1
I2
J1
13