FitDesk FDX 3.0 Owner's Manual page 11

ASSEMBLY
H
FIGURE 10
Step 11: Place the Desk (N) over the bikes Main Frame (K)
tighten the two Allen Bolts and Washers using attached
Allen Wrench . Figure 11
(AA)
Note: Do not over tighten.
Step 12: Once desk (N) is installed, connect the Meter Wire to
the wire from the frame. Slide the Meter Holder (Q) and Meter
Wire through the opening in the top center of the Desk, then
install and tighten the two screws (CC) through the Meter Holder.
Figure 12
M
M
Step 10: Place one Resistance Band Handle through the opening in the frame,
(K) then hang the handles (H) on the Resistance Band Hooks (3242) like
shown. Be sure to place the Tube into the metal loop. Figure 10
K
FIGURE 13
FIGURE 14
Q
WARNING: The Resistance Bands are for light use only.
Do not overstretch the Resistance Bands.
FIGURE 11
Q
Step 13: Remove the battery cover located on the back of
the Meter (M) (1906). Install the included two AAA batteries,
then replace the cover. F igure 13
Step 14: Slide the Meter (M) onto the Meter Holder (Q)
and then plug the Meter Wire (1908) into the back of the
Meter (M). Figure 14
9
N
CC
FIGURE 12
K
N