FitDesk FDX 3.0 Owner's Manual page 10

ASSEMBLY
FIGURE 6
G
Step 6: Assemble the Saddle (A) to the Saddle Tube (G).
using attached wrench
Note: Make sure the lock nuts are extra tight.
FitDesk
®
Note: The
Saddle Height Extender (C) for increased leg extension if
needed. It is recommended for use if you are taller than
5 feet 9 inches, or 175cm.
Step 8: Install the Saddle Back Assembly (D)
to the Saddle Post (G) using attached wrench
. Be sure the bolts sit flush in the square
(BB1)
holes (See Detail). Figure 8
D
FIGURE 8
DETAIL
Figure 6
(BB1)
is supplied with an optional
C
Step 7: To attach the Saddle (A) and Saddle Tube,
(G) loosen the Saddle Tube Adjuster Knob (HH).
Figure 7
Note: You do not have to remove the knob to adjust
the height. Loosen the knob and pull, then retighten
when the desired height is reached.
Step 9: Install the Saddle Back Cushion
(E) to the Saddle Post (D) using attached
Allen Wrench
Bolts (DD) and Lock Washers (EE) sit
flush in the holes. Figure 9
A
DD
DD
8
FIGURE 7
HH
. Be sure the Allen
(AA)
D
EE
EE
FIGURE 9
Note: Adjust the Saddle Back
tilt position by adjusting the Nut
and Allen bolt shown here.
G
E