Hardware Specifications - Contec PC-SDD64V User Manual

Hardware Specifications

Model
PC-SDD64V
Format capacity 64MB
Bus specification ATA (IDE-AT)
Transfer rate
ATA bus transfer rate 8.0Mbyte/sec(reading / writing)
Memory transfer rate
(Reading) 5.0Mbyte/sec
(Writing) 1.5Mbyte/sec
Access rate (Reading)*1 2.0Mbyte/sec (reading)
(Writing) *1 1.1Mbyte/sec
Data reliability Frequency of unrecoverable errors per bit:
ECC 64bits/Sector
Max. limit on number of 300,000 times per physical overwrites
overwrites
Rated voltage 5VDC ± 5%
Consumed power
standby 85mW (Typ.)
idle 175mW(Typ.)
reading 275mW (Max.)
writing 300mW (Max.)
Operating conditions
Temperature 0 to 60ºC
Humidity 8 to 95% (no condensation)
Storage temperature -20 to 80ºC
Anti-vibration 15G (Max.) (during operation)
Anti-shock 1000G (Max.) (during operation)
Sweep endurance 10 to 57 Hz/0.15 mm half amplitude and 57 to 150 Hz/2G for 80 minutes in each of the X, Y, and Z
directions (Conforming to JIS C0040 and IEC 68-2-6 when installed on IPC-BX/M6xx)
External dimensions 69.85(W) x 100(D) x 12.5(H)mm
Weight Approx. 100g
*1 An access rate is reference value. Value may not correspond by the use condition.
Note!
The number of times you can write to the silicon disk drive is limited.
Avoid using it if you need to write the data frequently.
PC-SDD V Series
Hardware Specifications
PC-SDD128V PC-SDD192V
128MB 192MB
2.5Mbyte/sec 3.0Mbyte/sec
1.4Mbyte/sec 1.6Mbyte/sec
Less than 1 / 10
PC-SDD V Series User's Guide
PC-SDD320V PC-SDD500V PC-SDD1000V PC-SDD2000V
320MB 512MB
3.0Mbyte/sec 3.0Mbyte/sec
1.6Mbyte/sec 1.6Mbyte/sec
14
reads
1024MB 2048MB
3.0Mbyte/sec 3.0Mbyte/sec
1.6Mbyte/sec 1.6Mbyte/sec
2