Troubleshooting Guide - Philips SBC RU 520 Manual

9 9 4 3
4
0 - 9
5
SHIFT
N
- The original function of the key will be overwritten. If you
want to return to its original function see the following section
about resetting.
- Remember: no functions can be performed by this remote
control that are not present on the equipment you are
operating!
Reset your remote control to its original
presets:
If you want to return to the original functions of all keys and
delete all added functions under programmed keys a simple
reset procedure is sufficient:
1
1 6
2
9 8 1
- The LED flashes twice to indicate a succesfull reset.
The keys on your remote control will now perform their
default functions.

TROUBLESHOOTING GUIDE

• Problem:
– Solution:
• Device is not responding and the green light does not flash
when you press a button.
– Replace batteries with two new 1.5 volt, type RO3, UM4 or
• Device is not responding, but the green light does flash when
you press a button.
– Aim the SBC RU520 at the device and be sure that there are
• The SBC RU520 is not performing commands properly.
– You may be using the wrong code. Try repeating Set up using
• You can't access teletext pages and you were used to use this
(fi) button to access teletext.
– Follow Set up procedure and at step 5 of section "Your
0
0
6
4
6
Instructions for use
Enter 9, 9 and 4, using the number keys.
Enter the 3-digit code you received from the helpline
using the number keys, within 30 seconds.
Press the key under which you want to store the new
function. The LED flashes twice to indicate a succesfull
installation.
If you want to store the function under a Shift/Key
combination; first press Shift, then press the required
function key.
O T E
Press and hold keys 1 and 6 simultaneously - for about
three seconds - until the green LED lights up.
Enter 9, 8 and 1, using the number keys.
AAA batteries.
no obstructions between the SBC RU520 and the device.
another code, listed under your brand, or start the Autosearch
Set-up over again to locate the proper code.
If the device still doesn't respond, call the help-line and we'll
put you back on track.
equipment is of another brand, or your equipment is a Philips
brand, but not all keys respond correctly" press keys
0, 0, 6 and 4.
To enter teletext pages, press the teletext cancel button.