Table of Contents
Advertisement
TIPS DURING OPERATION
MOWING PROCEDURE
1.
Always lay the cord on the ground near the outlet in neat, loose coils with the mower end of the
cord on top.
2.
It is important to arrange the cord systematically to avoid annoying loops and knots.
3.
Starting at the point nearest the electrical outlet, move back and forth across the lawn.
4.
Each lawn with its trees, shrubs, and other obstructions requires a different mowing procedure.
A little experimenting will enable you to determine the easiest method of handling the cord on
your lawn.
EMPTYING THE GRASS BOX
1.
When the grass box is full. Switch the mower off, disconnect the mower from the mains supply
and wait until the blade has come to a complete stop.
2.
Hold the handle of the collection box.
3.
Lift the collection box flap.
4.
Tilt the collection box backwards, whilst removing it away from the lawnmower.
5.
Empty the collection box.
TROUBLESHOOTING
PROBLEM
Motor does not run
Reduced Motor Power
The grass collector does
not fill completely
RESOLUTION
1. Check the mains connection cable, plug fuse and circuit breaker.
2. Start on short grass or on an area which has already been mown.
3. Unplug the mower. Clean the discharge chute/housing, the blade
must rotate freely.
4. Correct the cutting height.
1. Correct the cutting height.
2. Clean the discharge chute/housing.
3. Have the blade re-sharpened or replaced by an authorised service
dealer.
1. Correct the cutting height.
2. Allow the lawn to dry.
3. Have the blade re-sharpened or replaced by an authorised service
dealer.
4. Clean the grille on the grass catcher.
5. Clean the discharge chute/housing.
Advertisement
Table of Contents
