Table of Contents
Advertisement
The thermometer starts searching for the corresponding computer. When the con-
nection is established, a green LED above the display illuminates and the colour of
the Bluetooth™ icon on the connected computer changes. You can now transfer the
data to the application software of the thermometer. If the measurement button is not
pressed and data is not transferred, the thermometer switches off automatically after
approximately 7 seconds.
8.7.3 User-defined configuration (Bluetooth™)
Proceed as follows:
Open the handle of the thermometer and set the DIL switch 5 to ON (Set default).
Does „Default" appear in the display? The DIL switch 9 must be set to OFF (slave) at
this point in time without fail. Now start the Bluetooth module as described under the
passive mode.
Programming the thermometer with the help of BlueTool
Launch the Bluetooth software on your computer and start the device search. Doub-
le-click the infrared thermometer icon to establish a connection (indicated by the
green LED at top-left of the display and changed colour of the Bluetooth icon on your
computer).
You can view the properties by right-clicking the service under Serial Ports.
Note down the number of the connected ComPort.
Now launch the BlueTool application, enter this ComPort number and then click Connect.
A configuration window opens.
It shows various details about the device and multiple fields for invoking other setting
options.
33
Advertisement
Table of Contents
