About Batteries; Using The Lighted Keypad - Philips Magnavox REM380 User Manual

ABOUT BATTERIES

NOTE: The I-TV requires four (4) new "AAA"
alkaline batteries (not supplied). Do not mix
old and new batteries or mix alkaline with
manganese-type batteries.
Installing Batteries
1. On the back of the remote control, push
the tab and lift the battery compartment
cover off.
2. Match the + and – marks on the batteries
to the + and – marks in the battery case
and insert four (4) "AAA"alkaline batteries.
3. Press the battery cover back into place.
The tab should click when the cover is
locked.

USING THE LIGHTED KEYPAD

When activated, the I-TV remote control
features a lighted keypad that illuminates all
of the remote control keys whenever you
press any key.
1. To turn on the keypad back light,
press LIGHT once.The keypad will
remain lit for 5 seconds after you
release any key.
4
1
2
3
4. Test the unit by pressing POWER and any
Component key (e.g., TV, VCR, CBL, etc.).
If the batteries are inserted correctly, the
red indicator light will blink once.
Battery Saver
The I-TV has a Time-Out feature that will
automatically deactivate the remote control if
a key is depressed for more than 30 seconds.
This feature will help conserve the battery life
should your remote control get stuck in a
place where keys remain depressed (e.g.,
between the sofa cushions).
Replacement And Code Saver
When the batteries need replacing, the I-TV
remote control will stop working and will
require four (4) new "AAA"alkaline batteries
for continued operation. Once you remove
the old batteries, program settings and
codes will be saved for 10 minutes, allowing
adequate time to insert new ones.
However, if you do not replace the batteries
within the allotted time (i.e., 10 minutes),
you will have to reprogram the I-TV remote
control (see next page).
2. To turn off the keypad back light,
press LIGHT once again.(The key-
pad will not light whenever you
press any key.)