Philips Magnavox REM380 User Manual page 9

OPERATING YOUR REMOTE CONTROL
MCP Key (continued)
To Clear The MCP Key:
1. On the remote control,press and
hold SET until the red light
blinks twice, then release SET.
2. Enter 9-9-5. The red light will
blink twice.
Press MCP once.
3.
Press and hold SET until the red
4.
light blinks twice, then release
SET.
FC1 And FC2 Keys
The FC1 and FC2 keys can be setup to per-
form a number of functions with a single
key press once the selection is programmed.
Repetitive, time-consuming operations can
be grouped for easy, convenient access
through the press of one key.
The FC keys are ideal for home theater oper-
ations, setting a favorite channel, adding to
multiple component uses, guide steps or
other multiple functions you would like to
control with one key press. On one key, you
can define and program a sequence of events.
Moreover, each FC key can hold up to 15 key
presses, allowing optimal individual cus-
tomization. Below are a few examples to get
you started.
Programming A Favorite Channel
With so many channels available through
your cable system or satellite provider, a
favorite channel can be programmed for easy,
direct channel selection with one key press.
For example, let's assume your favorite pro-
grams are on channel 71. Use the following
instructions to program the FC1 or FC2 key
for this channel:
1. On the remote control, press and
hold SET until the red light blinks
twice,then release SET.
Enter 9-9-5. The red light will
2.
blink twice.
3. Press and release either FC1 or
FC2.
4.
5. Enter 7-1.
NOTE: If you have access to over
100 channels, enter in 071.
6. Press and hold SET until the red
light blinks twice, then release
SET.
Programming A Secondary MCP Key With
Instant Channel Selection
Just like the MCP key, the FC1 and FC2 keys
can be programmed to turn on and off your
equipment. For instance, let's say you want
your child to be able to easily turn on the
equipment and select their favorite channel.
You can setup a sequence on the FC1 or FC2
key to turn on the TV and cable box, and
then tune the cable box to a specific channel
(e.g., 11) with the push of one key.
1. On the remote control,press and
hold SET until the red light
blinks twice, then release SET.
Enter 9-9-5. The red light will
2.
blink twice.
3. Press and release either FC1 or
FC2.
4. Enter the following sequence:
CBL,
POWER,
TV,
POWER,
CBL, and
1-1 (or 0-1-1 if you have access
to over 100 channels)
Press and hold SET until the red
5.
light blinks twice, then release
SET.
Now when you press the programmed FC
key, the Cable box and TV will turn on and
the Cable box will tune to channel 11.
On the remote con-
trol, press TV, VCR,
CBL, or DSS once.
9