eLine ELI-SIP2-NVR32 Manual page 19

Click
cameras and click Ok.
To remove managed cameras, check the
select the cameras to be removed, and click Delete Camera.
Section 6: Management of the authentication accounts of cameras
Only successfully authenticated cameras can be used normally. Before adding a camera,
add the authentication account and password of the camera to the corresponding list.
To log in to a webcam, enter the corresponding authentication account. Only
successfully authenticated webcams can be added.
The system provides the default account admin and default password admin. Click

to add a camera authentication account.
To delete a camera authentication account, select the account and click

Section 7: camera setup
This section displays the statuses of webcams and provides setting of the names, IP
addresses, record policies, code streams, and motion detection of webcams.
The statuses of webcams include Online, Offline, and Account error.

To view live videos, click
Change the name of a webcam.

Enter a new name in the Name column.
Modify the IP address of a webcam.

1. Click the IP address to be modified. The Camera IP Setup dialog box appears.
2. Enter a new IP address. For details, s
Set a record policy.

1. Click the record policy to be modified. The Record policy Configuration
dialog box appears.
2. Enter a new record policy. For details,.
Set a code stream.

1. Click the code stream to be modified. The Stream dialog box appears, as shown
in Figure 5-6.
2. Enter a new code stream, set
The parameter settings are applied to all webcams with the same resolution.
. The Camera Search interface (shown in Figure 5-4) appears. Select
check box in the camera list,
following an online webcam.
Apply to All Devices
- 19 -
.
to On, and click OK.