Table of Contents
Advertisement
4.4 Shutdown
Do not cut off the power supply when the system prompts "Shutting down".
When the NVR is operating, avoid cutting off the power by turning off the power
switch on the rear panel or removing the power cord.
The NVR may not operate normally when a power supply exception occurs, likely
causing damage to the NVR in serious conditions. In such a circumstance, you are
advised to use a regulated power supply.
To shut down the NVR before logging in, press and hold the PWR button on the front
panel for over 3s. The NVR is closed successfully when the power indicator on the
front panel changes from steady on to flashing in red.
To shut down the NVR after logging in to the main interface, click
right corner or press and hold the PWR button on the front panel for over 3s. The
shutdown interface appears, as shown in Figure 4-3.
Figure 4-3 Shutdown interface
Enter a valid password and click Shutdown. When authentication is successful, the
prompt "Are you sure to shut down?" is displayed. Click Yes.
4.5 Login
Take the following steps to log in to the NVR:
Enter your user name and password on the login interface of the NVR.
Step 1
- 13 -
in the upper
Advertisement
Table of Contents
