Table of Contents
Advertisement
DCD-8 User Manual
18.2. MULTIPLIER RATES
Through WC outputs 7&8, the DCD-8 can apply a multiplier to the selected base frequency.
18.3. ERROR MESSAGES
Below is a complete list of all the error messages generated by the DCD-8 along with a
description and the menus concerned.
NOTE: These messages appear on the LCD display for about 3 1/2 seconds and may be
cancelled by any key press.
Same audio (group) cannot be source to both domains (see menus 06 & 07).
NOTE: the DCD-8 considers all AES & S/PDIF as a single source, as far as the audio
router is concerned
Can't choose ADAT as audio source when optical connectors switched to Optical S/
PDIF (see menus 06, 07 & 31)
Can't choose AES3 as audio source when optical connectors switched to Optical S/
PDIF (see menus 06, 07 & 31)
Can't choose Optical S/PDIF as audio source when optical connectors switched to
ADAT (see menus 06, 07 & 31)
Can't choose Optical S/PDIF reference when optical connectors switched to ADAT
- may occur when switching the optical input from Optical S/PDIF to ADAT (see
menus 02 & 31)
Can't choose ADAT or AES3 reference when optical connectors switched to Optical
S/PDIF - may occur when switching the optical input from ADAT to Optical S/PDIF
(see menus 02 & 31)
FSx1
FSx2
X
X
ENTER
FSx4
FSx64
FSx128
X
X
X
X
X
X
X
Page 23
FSx256
X
X
X
X
X
X
ENTER
-
Advertisement
Table of Contents
