Table of Contents
Advertisement
Page 14
NOTE: You can make a change to User X, go have a look at User Y, then come back
to User X and your change will still be there, whether saved or not. Of course, if you
leave the menu, you will lose any unsaved data, as usual.
8.19. MENU 99: DCD-8 SOFTWARE VERSION
Menu 99 displays the unit's software version number and its FireWire serial num-
ber. The FireWire serial number is pre-programmed at the factory and cannot be
changed. Identification over FireWire has to be different for each DCD-8 so that
more than one of them can co-exist on the same bus.
key is pressed.
9. Non-Volatile Storage
The DCD-8 has 4 user presets and a factory default preset (see menu 92).
In addition, it has non-volatile memory holding the current settings. This includes all DCD-8
settings such as rate and reference selections as well as output assignments. This memory
is continuously updated so that, when the unit is turned on, it is in the same condition as it
was when powered down.
NOTE: You should wait approximately 10 seconds after a change was entered before pow-
ering down, to allow for the flash memory to be updated.
10. Lock Status
The lock status of the DCD-8 is displayed in the center of the LCD display. Below are
frame rate.
UNLOCKED
Unable to lock
LOCKED --
Loose Lock
LOCKED -
Lock confirmation phase
DCD-8 User Manual
ENTER
ENTER
Advertisement
Table of Contents
