Table of Contents
Advertisement
DCD-8 User Manual
8. Menus Description
Please note that some of the menu options will change based on your selections. As an
example, if S/PDIF has been selected in menu 31 as the optical connector format, ADAT
no longer appears as a reference option in menu 02, and vice-versa.
8.1. MENU 01: RATE A
The DCD-8 has 2 domains, A & B. Each domain can have it's own rate. Menu 01
lets you change the A rate.
- In SET mode, a specific frequency can be selected;
- in AUTO mode, the reference's rate is mirrored and automatically selected.
NOTE: AUTO is not available if the reference is Internal, VSO or Video.
8.2. MENU 02: REFERENCE A
Menu 02 lets you select a reference for the A domain from the following choices:
GPS: WC inputs can also accept and detect a 10MHz 5volt TTL signal, such as those
NOTE: Some of the choices listed above may not always be available.
When selecting an external source, a RATE menu appears on the bottom line. RATE has
2 modes:
For more information on Set vs. Learn, go to chapter 11.
VSO: When VSO is selected, the bottom line shows the speed adjustment, measured
in cents (semitone/100), with a parallel readout of the corresponding percentage
speed change. The VSO range is +/- 200 cents
12 for more on VSO.
NOTE: When adjusting the VSO cents value in the menu, the changes take effect immedi-
Internal
WClk 2
VSO
WClk 3
WClk 1
AES 1
- LEARN, the DCD-8 determines the incoming rate,
- SET, the user determines the incoming rate.
. Adjustments are Fine (1 cent steps) or Coarse (10 cents steps). See chapter
AES 2
AES 3
S/PDIF
ENTER
Page 9
ADAT
Optical
Video
Advertisement
Table of Contents
