Removing The Battery; Charging The Battery - Datamax OC-2 series User Manual

OC-2 SERIES OF PRINTERS USER'S GUIDE
Note: Do not force the battery into the battery cavity.
When inserted properly, the battery easily slides and locks
into place. If the battery does not easily slide into place,
re-insert the battery.
6. Close the printer cover (Figure 13).
Figure 11
7. Charge the battery (batteries are shipped uncharged). For
more information, see "Charging the battery" on page 4.

Removing the battery

1. Lift the battery up and out of the battery cavity while sliding
it to the left (Figure 14).
2. Remove the battery from the battery cavity (Figure 15).
Figure 14

Charging the battery

The battery status LED will glow red if the battery charge is
low and the printer is powered on. (For more information, see
"Using the control panel" on page 12.)
Charge the battery as follows:
1. Verify the battery is installed correctly.
Figure 12
Figure 15
4
Figure 13