Operating Your Heater - RD WORKS FP404R-Q Owner's Manual

Remote Control
Power button: Powers the display on and off.
Up button: For setting temperature or time upward
Down button：For setting temperature or time downward
Flame light button: Adjust the brightness of the flame
Heater button: Set up the heater mode and turn off
Timer button: User setting timing boot or shutdown
PREPARATION
Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power
outlet.
And turn on the power switch in the rear of the unit. Only operate heater in upright
position with caster wheels attached.
Insert 2 AAA batteries into the remote control before using (Batteries Not Included)

OPERATING YOUR HEATER

Once the Electric fireplace has been properly assembled and connected to an
electrical outlet and make sure the main switch is "ON"(main switch light is
shining), it is ready to operate:
7