Power On/Off And Earphone Connection Waiting Mode - Phiaton BT 100 NC Owner's Manual

5. POWER ON/OFF AND EARPHONE CONNECTION WAITING MODE

Power ON/OFF
ON : 2 Seconds
OFF : 2.5 Seconds
Status Operation
Press and hold the CALL/
ON
POWER button for 2 seconds
Press and hold the CALL/
OFF
POWER button for 2.5 seconds
※ Pairing mode will start once the power is turned on for the first time after purchase.
※ When the BT 100 NC is not in use, ensure the NC function is switched OFF.
If left in the ON position, this will cause the battery to run out. If the NC Function
is switched ON even after the power is turned off, it is displayed in blue lights to
LED indicator.
2) Connection Waiting Mode
- When power is turned on, 'Connection Waiting Mode' will start if 'Pairing Mode' cannot be
entered or the earphones cannot connect with 'Bluetooth Device'.
- If the 'Bluetooth Device' is not connected within 5 minutes in 'Connection Waiting Mode',
the earphones will automatically turn off.
Status
Connection Waiting Mode
1) Power ON/OFF
- Press and hold the [CALL/POWER] Button for 2 seconds to
turn the power on.
- When turning the power off, press and hold the [CALL/POWER]
Button for 2.5 seconds to turn off. (While on an incoming call,
you cannot power off the device.)
- When turning power on/off, there is a vibration notification
that rings.
LED Indicator
Purple light turns
on for 1 second
Red light blinks
5 times
Blue light blinks twice in 6 second intervals
Vibration Notification
Vibrates once for
0.3 second
Vibrates twice for
0.3 second
LED Indicator
4