Using The Call Function - Phiaton BT 100 NC Owner's Manual

13. USING THE CALL FUNCTION

1) Accepting a Call
- When the incoming call tone is heard through the
earphones or the incoming call vibration is ringing,
press the CALL/POWER Button.
(Adjusting Call Volume: to control the call volume,
Press the (+)/(-) Button.)
2) Ending a Call
- While on a call, shortly pressing the CALL/POWER
Button to end the call.
3) Rejecting a Call
- When the incoming call tone is heard through the
earphones or the incoming call vibration is ringing,
press and holds the CALL/POWER Button for about
1 second. (After hearing the 'beep' signal tone, the
incoming call is rejected and the voice guidance
"Call Ignored" is heard.)
4) Turning Mute On/Off
- While on a call, press the (-) Button for about 1 second to mute microphone. To turn back on,
press the (-) Button again for about 1 second.
5) Call Waiting
- When there is another incoming call while on a call. (Supported only when having applied for
this service with your telecom provider.)
- Press and hold the CALL/POWER Button for about 1 second to place the current call on call
waiting and connect the second call. (Press the CALL/POWER Button again for about 1 second
to switch between the waiting call and connected call.)
- Shortly press the CALL/POWER Button to end the current call and connect the second call.
6) Calling by Voice (Supported within mobile phones that support the voice command feature).
- While waiting, shortly press the CALL/POWER Button.
7) Switching between the Device and Mobile Phone
- To switch the call from mobile phone to the headphone, press the CALL Button for 1 second.
Status
Incoming Bell/Outgoing Bell
During Call
When there are two calls connected
8) Stopping Incoming Call Vibration
- During an incoming call, you can press the (-) button for 1 second to stop the vibration notification.
You will then only hear the incoming call tone.
Play Button
L Side Body
(+) Button
LED Indicator
Purple light blinks in 1.5 second intervals
Blue light slowly blinks every 6 seconds
Purple light slowly blinks every 6 seconds
Call/Bluetooth
Power Button
(-) Button
9