1 , 2 Usb Ports - IBM FlashSystem 840 Installation Manual

Procedure
10. Before you proceed, ensure that the system is powered on.
11. Remove the USB flash drive from the computer. Insert the USB drive into the
1
Figure 21. USB ports
38
FlashSystem 840: Installation Guide
1. Gather the information that you will use to configure the system.
v You must have the IP network address that you will use to manage the
system.
– IP address
– Subnet mask
– Gateway
v Other information is optional, but useful for enabling more capabilities.
– The IP address of a Network Time Protocol (NTP) server for automated
setting of date and time
– The IP address of a simple mail transfer protocol (SMTP) server for
sending automated notifications of alerts. When this Call Home feature is
enabled, the system notifies IBM of system health and failures.
2. Locate the USB flash drive that was included with your order in the
documentation package.
3. Insert the USB flash drive into a USB port on the computer.
4. Open a terminal window.
5. Locate the root directory of the USB flash drive. The root directory is usually
located in the /Volumes/ directory.
6. Type: sh InitTool.sh The initialization tool wizard starts.
7. On the Tasks page, select Yes to configure a new system. If you already
initialized the system but are unable to access it, select No. If you select No,
more options become available.
8. On the Encryption page, select No to indicate that you do not have a license
to activate encryption on the system.
9. On the Management IP page, enter the IP address, Subnet mask, and
Gateway information. Click Apply and Next.
port on the left canister to allow the system to initialize. Figure 21 shows the
locations of the USB ports.
2

1 , 2 USB ports