Table of Contents
Advertisement
CAUTION:
v Do not install a unit in a rack where the internal rack ambient temperatures
v Do not install a unit in a rack where the air flow is compromised. Ensure that
v Consideration should be given to the connection of the equipment to the
v (For sliding drawers) Do not pull out or install any drawer or feature if the
v (For fixed drawers) This drawer is a fixed drawer and must not be moved for
(R001 part 2 of 2)
16
FlashSystem 840: Installation Guide
will exceed the manufacturer's recommended ambient temperature for all your
rack-mounted devices.
air flow is not blocked or reduced on any side, front, or back of a unit used
for air flow through the unit.
supply circuit so that overloading of the circuits does not compromise the
supply wiring or overcurrent protection. To provide the correct power
connection to a rack, refer to the rating labels located on the equipment in the
rack to determine the total power requirement of the supply circuit.
rack stabilizer brackets are not attached to the rack. Do not pull out more than
one drawer at a time. The rack might become unstable if you pull out more
than one drawer at a time.
servicing unless specified by the manufacturer. Attempting to move the
drawer partially or completely out of the rack might cause the rack to become
unstable or cause the drawer to fall out of the rack.
Hide quick links:
Advertisement
Table of Contents
